Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge C4130 Owner's Manual

Removing an AC power supply unit

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

CAUTION: The system requires one power supply unit (PSU) for normal operation. On power-redundant systems, remove and install only one PSU at a time in a system that is powered on.

  1. Follow the safety guidelines listed in the safety instructions section.
  2. Disconnect the power cable from the power source and from the PSU you intend to remove.
  3. Remove the cables from the strap on the PSU.

Steps

Press the release latch and slide the PSU out of the PSU slot by holding the PSU handle.
Figure 1. Removing an AC PSU
This figure shows removing an AC PSU.
  1. release latch
  2. PSU cable connector
  3. PSU
  4. connector
  5. PSU handle

Next steps

Depending on your requirement, perform one of the following steps:

  • If you are not replacing PSU 2 immediately, install a PSU blank.
  • Install the replacement AC PSU.
  • Install the 2.5 inch hard drive cage.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\