Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge C4130 Owner's Manual

PDF

Installing the system top cover (back)

Prerequisites

  1. Follow the safety guidelines listed in the safety instructions section.
  2. Ensure that all internal cables are connected and routed correctly.
  3. Keep the Phillips #1 screwdriver ready.

CAUTION: Closing the system cover with incorrect cable routing can damage the cables.

Steps

  1. Align the slots of the system top cover with the tabs on the chassis.
  2. Align the guide pin on the back of the chassis with the guide slot on the back of the cover.
  3. Slide the cover towards the front of the chassis until the guide pin on the back of the chassis locks on the back of the cover.
  4. Secure the system top cover to the chassis by using the screws.
    Figure 1. Installing the system top cover (back)
    This figure shows installing the system top cover (back).
    1. system top cover (back)
    2. guide slot on the system cover
    3. tab on the chassis (6)
    4. screw (2)

Next steps

CAUTION: Turn on the system only when both the system top covers are installed.

  1. Install the system into the rack.
  2. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\