Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge C4130 Owner's Manual

Installing the optional 2.5 inch hard drive cage cover

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in before working inside your system.
  3. Remove the hard drive cage.
  4. If applicable, install the 2.5 inch hard drive(s) into the hard drive cage.
  5. Connect the power and signal cable(s) to the hard drive(s) in the hard drive cage.

Steps

  1. Lower the hard drive cage cover onto the hard drive cage.
  2. Slide the hard drive cage cover toward the back of the cage to engage it with the slots on the hard drive cage.
  3. Use the screws to secure the hard drive cage cover to the hard drive cage.
    Figure 1. Installing the 2.5 inch hard drive cage cover
    This figure shows installing the 2.5 inch hard drive cage cover.
    1. slot on the hard drive cage (2)
    2. hard drive cage
    3. hard drive cage cover
    4. screw (2)

Next steps

  1. Install the hard drive cage into the PSU 2 slot/2.5 inch hard drive slot on the chassis.
  2. Follow the procedure listed in after working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\