Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge C4130 Owner's Manual

PDF

Removing a GPU riser cable board

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified service technicians.

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Keep the Philips #2 screwdriver ready.
  3. Remove the GPU from the chassis.
  4. Disconnect the power cables connected to the GPU.

Steps

  1. Remove the screws securing the GPU riser cable board to the GPU.
  2. Pull the GPU riser cable board to disengage the connector on the GPU riser cable board from the GPU.
  3. Remove the GPU riser cable routed through the GPU riser cable clip.
    Figure 1. Removing a GPU riser cable board
    This figure shows removing of a GPU riser cable board.
    1. connector on the GPU riser cable board
    2. GPU riser cable board
    3. GPU riser cable
    4. screw (3)
    5. GPU riser cable clip
    6. GPU

Next steps

Removing the custom GPU brackets from the GPUs removed from your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\