Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge C4130 Owner's Manual

PDF

Removing a SXM2-GPU Heat Sink

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the NVLink air shroud.

Steps

  1. Using a Phillips #1 screwdriver, loosen the screws on the heat sink in the order mentioned below:
    1. Loosen the first screw three turns.
    2. Loosen the screw diagonally opposite to the screw you loosened.
    Figure 1. Removing SXM2-GPU heat sink screws
    This image shows how to remove screws securing the SXM2-GPU heat sink.
  2. Repeat the procedure for the remaining two screws.
  3. Return to the first screw to loosen it.
  4. Following the same diagonal pattern, loosen the remaining screws completely.
  5. Lift the heat sink from the NVLink board.
    Figure 2. Removing SXM2-GPU heat sink
    This image shows how to remove SXM2-GPU heat sink from the system.

Next steps

  1. Remove a SXM2 GPU.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\