Dell Latitude 3500 Service Manual

Installing the power button board with optional fingerprint reader

Steps

  1. Place the power-button board into the slot on the palmrest and keyboard assembly [1].
  2. Replace the two (M2x3) screws that secure the power button board to the palmrest and keyboard assembly [2].
    Installing the power button board
  3. Affix the power button cable to the palmrest and keyboard assembly [1].
  4. Slide the power button cable and fingerprint reader cable to the system board and close the latch to secure the cable [2].
    Installing the power button board

Next steps

  1. Replace the display assembly.
  2. Replace the system fan.
  3. Replace the battery.
  4. Replace the base cover.
  5. Replace the SD memory card.
  6. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\