Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

PowerProtect Data Manager 19.10 Oracle RMAN User Guide

Add protection storage

Add and configure protection storage to use as a target for protection policies. Adding protection storage requires the Administrator role.

Prerequisites

NOTE

When adding a High Availability PowerProtect DD system, observe the following points:

  • Do not add the individual active and standby DD systems to PowerProtect Data Manager.
  • In the Address field, use the hostname that corresponds to the floating IP address of the High Availability PowerProtect DD system.
  • The High Availability PowerProtect DD system is verified with the root certificate.

About this task

The PowerProtect Data Manager Administration and User Guide provides more information about protection storage and related concepts:

  • High availability options
  • Smart Scale system pools, a single interface to a flexible group of pool members
  • Working with protection storage
  • Working with storage units

Steps

  1. From the left navigation pane, select Infrastructure > Storage.
    The Storage window appears.
  2. In the Protection Storage tab, click Add.
  3. In the Add Storage dialog box, select a storage system (PowerProtect DD System or PowerProtect DD Management Center).
    For a system pool, select DDMC.
  4. To add a High Availability PowerProtect DD system, select the checkbox.
  5. Specify the storage system attributes:
    1. In the Name field, specify a storage name.
    2. In the Address field, specify the hostname, fully qualified domain name (FQDN), or the IP address.
    3. In the Port field, specify the port for SSL communication. Default is 3009.
  6. Under Host Credentials click Add, if you have already configured protection storage credentials that are common across storage systems, select an existing password. Alternatively, you can add new credentials, and then click Save.
  7. If a trusted certificate does not exist on the storage system, a dialog box appears requesting certificate approval. Click Verify to review the certificate, and then click Accept.
  8. Click Save to exit the Add Storage dialog and initiate the discovery of the storage system.
    A dialog box appears to indicate that the request to add storage has been initiated.
  9. In the Storage window, click Discover to refresh the window with any newly discovered storage systems.
    When a discovery completes successfully, the Status column updates to OK.
  10. To modify a storage system location, complete the following steps:
    A storage system location is a label that is applied to a storage system. If you want to store your copies in a specific location, the label helps you select the correct storage system during policy creation.
    1. In the Storage window, select the storage system from the table.
    2. Click More Actions > Set Location.
      The Set Location window appears.
    3. Click Add in the Location list.
      The Add Location window appears.
    4. In the Name field, type a location name for the asset, and click Save.

Results

PowerProtect Data Manager displays external DD systems only in the Storage window Name column. PowerProtect Data Manager displays PowerProtect DD Management Center storage types in the Managed By column.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\