In OS10 VTEP, the controller configuration
command initializes a connection to an OVSDB-based controller.
OS10 supports only one controller connection at a time.
NOTE Currently, the only
supported OVSDB-based controller is NSX.
To configure an OVSDB
controller on the OS10 VTEP:
Enable VXLAN in CONFIGURATION mode.
OS10(config)# nve
Changes the mode to CONFIGURATION-NVE-OVSDB from where you can configure
the controller parameters.
OS10(config-nve)# controller ovsdb
Specify the IP address, OVSDB controller port, and SSL as a secure
connection protocol between the OS10 VTEP and the controller in CONFIGURATION-NVE-OVSDB
mode.
OS10(config-nve-ovsdb)# ip ip-address port port-number ssl
The range of port-numberis from 0 to 65535. Configure the port-number as 6640 and the connection type as SSL.
(Optional) Specify a time interval, in milliseconds (ms). This is
the duration the switch waits between the connection attempts to the
controller.
OS10(config-nve-ovsdb)# max-backoff interval
The range is from 1000 to 180,000 ms. The default
is 8000 ms.
OS10# configure terminal
OS10(config)# nve
OS10(config-nve)# controller ovsdb
OS10(config-nve-ovsdb)# ip 10.11.66.110 port 6640 ssl
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\