- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw List
- Major components of Inspiron 15 3511
- Secure Digital Card
- Base cover
- Battery
- Memory modules
- WLAN card
- Solid-state drive
- Hard drive
- System fan
- Heat sink
- Speakers
- IO board
- Touchpad
- Display assembly
- Hinge caps
- Display bezel
- Hinges
- Display panel
- Camera
- Display eDP cable
- Display back-cover
- Power button
- Power button with fingerprint reader
- System board
- Power-adapter port
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System diagnostic lights
- Recovering the operating system
- Real Time Clock—RTC reset
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Inspiron 15 3511 Service Manual
Pre-boot Behavior
This section provides Pre-boot Behavior details and settings.
| Options | Description |
|---|---|
| Adapter Warnings | |
| Enable Adapter Warnings |
This field contains a toggle switch to enable or disable warning messages during boot when adapters with low power capacity are detected (enabled by default). |
| Warning and Errors | |
| Warning and Errors |
This field allows the user to enable or disable boot process to be paused only when warnings or errors are detected. The options are as follows:
|
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\