- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw List
- Major components of Inspiron 15 3511
- Secure Digital Card
- Base cover
- Battery
- Memory modules
- WLAN card
- Solid-state drive
- Hard drive
- System fan
- Heat sink
- Speakers
- IO board
- Touchpad
- Display assembly
- Hinge caps
- Display bezel
- Hinges
- Display panel
- Camera
- Display eDP cable
- Display back-cover
- Power button
- Power button with fingerprint reader
- System board
- Power-adapter port
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System diagnostic lights
- Recovering the operating system
- Real Time Clock—RTC reset
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Inspiron 15 3511 Service Manual
Removing the display panel
Prerequisites
- Follow the procedure in before working inside your computer.
- Remove the SD card.
- Enter service mode.
- Remove the base cover.
- Remove the WLAN card.
- Remove the display assembly.
- Remove the hinge caps.
- Remove the display bezel.
About this task
The following images indicate the location of the display panel and provides a visual representation of the removal procedure.
Steps
- Use a plastic scribe to pry the display panel from the bottom-right corner.
- Gently start prying the display panel along the left and right sides of the display back-cover using your hands.
- Lift the bottom side of the display panel and slide it downward to release the display brackets from the slots at the top side of the display cover.
- Gently flip the display panel assembly forward, peel back the Mylar tape securing the display cable on the rear of the display panel.
NOTE: Ensure that the panel has a clean and smooth surface to rest on to prevent damage.
- Disconnect the display cable from the display panel assembly and lift the display panel away from the system.
NOTE: Do not remove the metal brackets from the panel.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\