Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Inspiron 15 5510 Service Manual

PDF

Installing the display assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the display assembly and provides a visual representation of the installation procedure.

Align and place the palm-rest and keyboard assembly on the display assembly

Replace screws and connect display cable to its connector

Steps

  1. Slide the display assembly at an angle, and place the display assembly on the palm-rest and keyboard assembly.
  2. Using the alignment posts, close the display hinges.
  3. Replace the three (M2.5x4) screws that secure the right-display hinge to the system board.
  4. Replace the three (M2.5x4) screws that secure the left-display hinge to the system board.
  5. Slide the display cable into the connector on the system board and close the latch to secure the cable.
  6. Adhere the tape that secures the display cable to the system board.

Next steps

  1. Install the base cover.
  2. Exit Service Mode.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\