Integrated Dell Remote Access Controller 8 (iDRAC8) Version 2.00.00.00 RACADM Command Line Interface Reference Guide

Output

The getniccfg subcommand displays an appropriate error message if the operation is not successful. Otherwise, the output is displayed in the following format:

IPv6 settings:

IPv6 Enabled       = 0

DHCP6 Enabled      = 1

IP Address 1       = ::

Gateway            = ::

Link Local Address = ::

IP Address 2       = ::

IP Address 3       = ::

IP Address 4       = ::

IP Address 5       = ::

IP Address 6       = ::

IP Address 7       = ::

IP Address 8       = ::

IP Address 9       = ::

IP Address 10      = ::

IP Address 11      = ::

IP Address 12      = ::

IP Address 13      = ::

IP Address 14      = ::

IP Address 15      = ::

LOM Status:

NIC Selection   = Dedicated

Link Detected   = Yes

Speed           = 10Mb/s

Duplex Mode     = Half Duplex

Active NIC = Dedicated
                                 Static IPv4 settings:Static IP Address = 192.168.0.120
                                 Static Subnet Mask = 255.255.255.0
                                 Static Gateway = 192.168.0.1
                                 Static IPv6 settings:Static IP Address 1 = ::
                                 Static Prefix Length = 64Static Gateway = ::