You can view a list of connected clients, network throughput, network errors, and protocol operations within the Client Performance report.
For this example, you are researching into clients experiencing performance issues through specific protocols.
Click the
Performance Reporting tab.
On the
Live Performance Reporting page, click the
Cluster drop down and select the cluster that you want to monitor.
Click the
Report Type drop down and select
Client Performance.
In the
Date Range fields, select a range to display, then click
View Report.
The date range should include the entire period of time when the cluster was behaving unexpectedly. The default setting is to view the last hour of data.
The modules in the report are now populated with data for the cluster and date range you selected.
In the
Client Summary module, click the
Client with the highest Total I/O.
The modules below the
Client Summary are now populated with data for the client you selected.
In the
Protocol Operations Average Latency module, click the
Protocol breakout.
To remove focus on a breakout, click the
None breakout.
On the left side of the module, you can now see a list of all protocols being used by the client you selected. The protocol at the top of the list experienced the highest average latency during the date range you specified.
With the information you gathered, you can determine the client with the highest Total I/O, and the protocols the client used to access the cluster.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\