- Notes, cautions, and warnings
- Working on your computer
- Removing and installing components
- Software
- BIOS setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 7420/Latitude 7420 2-in-1 Service Manual
Removing the solid-state drive
Prerequisites
- Follow the procedure in before working inside your computer.
- Remove the microSD card.
- Remove the base cover.
About this task
The following images indicate the location of the solid-state drive and provide a visual representation of the removal procedure.
Steps
- Remove the screw (M2x2) that secures the SSD shield and remove the shield from the SSD.
- Remove the screw (M2x2) that secures the SSD to the system board.
- Slide and remove the solid-state drive from the M.2 slot on the system board.
NOTE:A thermal pad is included with the SSD plate and must always be adhered to the plate. If the thermal pad gets separated from the plate or is adhered to the SSD, stick back the thermal pad to the SSD plate before reinstalling the plate to the SSD.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\