- Notes, cautions, and warnings
- Working on your computer
- Technology and components
- Major components of your system
- Disassembly and reassembly
- Base cover
- Battery
- Memory modules
- WLAN card
- WWAN card
- Hard-drive assembly
- Coin-cell battery
- DC-in port
- Solid-state drive
- Inner frame
- Touchpad buttons
- SmartCard reader
- Touchpad buttons
- LED board
- Speakers
- Heatsink assembly-Discrete
- Heatsink assembly-UMA
- System board
- Keyboard assembly
- Keyboard bracket
- Power button
- Display assembly
- Display bezel
- Hinge caps
- Display panel
- Palmrest assembly
- Troubleshooting
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- LED Indicators and Characteristics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help
Dell Latitude 5501 Service Manual
Installing the display bezel
Prerequisites
About this task
The figure indicates the location of the display bezel and provides a visual representation of the installation procedure.
Steps
Align the display bezel with the display back-cover and antenna assembly, and gently snap the display bezel into place.
Next steps
- Install the display assembly.
- Install the WWAN card.
- Install the WLAN card.
- Install the battery.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\