iDRAC 8/7 v2.70.70.70 RACADM CLI Guide

Description	Tests the RAC’s SNMP trap alerting feature by sending a test trap from iDRACCMC to a specified destination trap listener on the network. To run this subcommand, you must have the Test Alert permission. NOTE: : Before you run the testtrap subcommand, make sure that the specified index in the RACADM iDRAC.SNMP.Alert group is configured properly. The indices of testtrap subcommand is co-related to the indices of iDRAC.SNMP.Alert group. NOTE: : Before you run the testtrap subcommand, make sure that the specified index in the cfgAlerting group is configured properly.
Synopsis	racadm testtrap -i <index>
Input	-i <index> — Specifies the index of the trap configuration that must be used for the test. Valid values are from 1 to 4.
Example	Enable the alert. racadm set idrac.emailalert.1.CustomMsg 1 racadm set iDRAC.SNMP.Alert.1.Enable 1 Set the destination email IP address. racadm set iDRAC.SNMP.Alert.1.DestIpAddr 192.168.0 View the current test trap settings. racadm get iDRAC.SNMP.Alert.<index> where <index> is a number from 1 to 8 Send a test trap to the destination configured for index 1: racadm testtrap -i 1

Welcome