Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

iDRAC 8/7 v2.70.70.70 RACADM CLI Guide

PDF

cfgNicStaticUseDhcp (Read or Write)

Table 1. Details of cfgNicStaticUseDhcp The following table provides the details of cfgNicStaticUseDhcp subcommand:
Description

Specifies whether DHCP is used to configure the IPv4 network.

Legal Values
  • 0 — IP Address, subnet mask and gateway are configured on the device.
  • 1 — IP Address, subnet mask and gateway are assigned from the DHCP server.
Default

0 — Do not use DHCP

NOTE: : If this object is modified, then the object cfgNicUseDhcp is also modified.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\