Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerStore Installation and Service Guide for PowerStore 1000, 1200, 3000, 3200, 5000, 5200, 7000, 9000, and 9200

PDF

Install an I/O module

About this task

NOTE:Move the I/O modules from the source to the target one at a time. The I/O modules must be moved into the corresponding slots on the target node.
NOTE:The figures below show the I/O module in the top node installed in the rack. The top node is upside down in the rack, so the alignment of the I/O module is reversed when the node is on a work surface.

Steps

  1. Align the module with the empty slot and carefully push the module into the slot.
    Figure 1. Installing an I/O module
  2. When the I/O module appears seated, push and release the small button on the handle.
    • If the button remains in, the module is fully seated.
    • If the button springs back, gently push the module further into the chassis, then push it again.
    • If the button still does not rest flush with its handle, remove the module and repeat steps 1 and 2.
    Figure 2. Locking in the I/O module

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\