Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerStore Installation and Service Guide for PowerStore 1000, 1200, 3000, 3200, 5000, 5200, 7000, 9000, and 9200

PDF

Remove the embedded module

About this task

NOTE:The figures below show the embedded module in the top node installed in the rack. The top node is upside down in the rack, so the alignment of the embedded module is reversed when the node is on a work surface.

Steps

  1. Push the orange tab on the embedded module to release the lever.
    Figure 1. Releasing the lever on the embedded module
  2. Pull the release lever away from the system. The embedded module releases from the system as you pull the lever.
    Figure 2. Removing the embedded module from the system
  3. Remove the embedded module from the slot.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\