Configure a remote system connection between a
PowerStore system and a PowerProtect DD system to enable remote backup.
Prerequisites
Before adding the remote connection, ensure that you have obtained the following PowerProtect DD system details:
PowerProtect DD appliance IP address
Storage unit name
Data transfer parameters
NOTE:Creating a remote system with invalid storage unit user credentials, results in a data connection loss. In that case, the Status column in
Protection > Remote System > [PowerProtect DD] > Connectivity displays Authentication Failure. Select
Modify for the PowerProtect DD and correct the invalid credentials. For more information, see Dell Knowledge Base Article 000208506 (If the PowerProtect DD user account password is changed...).
About this task
NOTE:You can add a single PowerProtect DD appliance to the same
PowerStore cluster multiple times, using a different storage unit ID each time. That way, you can back up different resources to different locations within a single PowerProtect DD system.
NOTE:If the storage unit is removed from the DD system, a complete data connection loss occurs, and remote sessions and snapshots must be cleaned up. For more information, see Dell Knowledge Base Article 000208497 (If a Storage Unit is removed from DD...).
Steps
Select
Protection > Remote Systems.
In the
Remote Systems window, click
Add.
In the
Add Remote System slide-out panel, configure the following fields:
Remote system type - Select
PowerProtect DD.
Management IP address
Description (optional)
Management username and password
Storage unit name
Data transfer IP address, username, and password
Set the Enable encryption option.
When encryption is disabled, the connection with
PowerStore does not use TLS and authentication.
When encryption is enabled the
PowerStore connection uses the DD Boost Two Way Password authentication mode, and negotiates the encryption level that is based on the DD Boost Global Security Settings.
NOTE:It is recommended to enable encryption when the remote system is DDVE in cloud.
Click
Add.
In the
User Authorization panel, verify the remote system certificate and click
Confirm to create the remote connection.
Results
The new system is added to the
Remote Systems list. The type of the system is PowerProtect DD, and the Capability is Remote Backup.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\