Retrieve a remote snapshot to the same
PowerStore cluster
About this task
You may want to retrieve a remote snapshot to the same
PowerStore cluster on which the source resource resides, when you must restore the parent resource or create a thin clone. You can retrieve a remote snapshot of a resource whether it still exists or is deleted.
Steps
Click
Protection > Remote Backup and select the
Resources tab.
The
Resources tab displays all resources (volumes and volume groups) that have associated remote snapshots.
In the Resources list, click the checkbox next to the resource and select
Manage Snapshots to view all the backups created for that resource.
In the
Manage Snapshots panel, select the snapshot that you want to retrieve and click
Retrieve.
In the confirmation message, click
Retrieve.
A Retrieve session is created for the snapshot and added to the Retrieve Sessions table. If the source resource exists on the cluster, a local snapshot is created under the source resource, and the retrieved backup is copied to it. The retrieval can be of a full copy or include only of the differences between the backup and the resource (incremental copy), depending on the last backup. If the source resource no longer exists on the cluster, a new volume or volume group is created on the
PowerStore cluster, as well as a local snapshot to which the remote snapshot is copied.
You can monitor the progress of the retrieve session in
Protection > Remote Backup > Retrieve Sessions.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\