Configure a NAS server in a DRT environment using REST API
About this task
NOTE:If you are not using REST API, skip this section.
Steps
To clone the NAS server in the specified namespace, run
/nas_server/{id}/clone, and specify
is_dr_test as true.
To create a network interface, run
/file_interface and specify the private network parameters.
NOTE:This step creates the file interface for the cloned NAS server using the same IP address, netmask, and gateway as the production NAS server. Use the bond interface/IP_Port that is associated with the private network.
Results
The NAS server is up and can be used for DRT in the isolated network.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\