- Notes, cautions, and warnings
- Additional Resources
- Introduction
- Remote Systems
- Snapshots
- Protection Policies
- Replication
- Asynchronous replication
- Synchronous replication
- Pause a replication session
- Resume a replication session
- Failover
- Other considerations for replication
- Testing disaster recovery for NAS servers under replication
- Virtual volumes replication
- Metro Protection
- Pre-requisites and limitations
- Configure host connectivity
- Metro witness
- Configure a metro volume
- Configure a metro volume group
- Set the metro role
- Monitor metro resources
- Pause a metro resource
- Resume a metro resource
- Promote a metro resource
- Demote a metro resource
- End a metro resource
- Summary of allowed actions on a metro resource
- Using protection policies with metro
- Using QoS with metro
- Remote Backup
- NDMP Backup for NAS Servers
- Replication summary
- Use cases
Dell PowerStore Protecting Your Data
Alert threshold
When you configure an asynchronous replication rule, you can specify an alert threshold, which is the amount of time the system waits before generating a compliance alert when a replication session does not meet the RPO. Setting the alert threshold to zero means that alerts will be generated if the actual synchronization time exceeds the RPO.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\