A replication rule is a set of parameters the system uses to synchronize data in a replication session. The parameters include selecting a replication destination, replication type, and setting a recovery point objective (RPO).
After you have configured a replication rule, you can choose to use it in a new or existing protection policy, which then automatically changes or applies the replication session parameters for any storage resource that uses the protection policy.
You cannot change a protection policy to use a different replication rule with a different remote system. To change a protection policy with a replication rule using a different remote system, remove the old policy before assigning a new one.
NOTE:Changing a remote system requires a full synchronization.
If you want to create a replication rule in addition to the existing rules, it is recommended to review the parameters and your business requirements with an administrator before proceeding. This can help in achieving and maintaining consistent policies across the system.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\