- Notes, cautions, and warnings
- Additional Resources
- Introduction
- Remote Systems
- Snapshots
- Protection Policies
- Replication
- Asynchronous replication
- Synchronous replication
- Pause a replication session
- Resume a replication session
- Failover
- Other considerations for replication
- Testing disaster recovery for NAS servers under replication
- Virtual volumes replication
- Metro Protection
- Pre-requisites and limitations
- Configure host connectivity
- Metro witness
- Configure a metro volume
- Configure a metro volume group
- Set the metro role
- Monitor metro resources
- Pause a metro resource
- Resume a metro resource
- Promote a metro resource
- Demote a metro resource
- End a metro resource
- Summary of allowed actions on a metro resource
- Using protection policies with metro
- Using QoS with metro
- Remote Backup
- NDMP Backup for NAS Servers
- Replication summary
- Use cases
Dell PowerStore Protecting Your Data
Modify the witness parameters
About this task
NOTE:If you want to change the witness IP address or FQDN, you must remove and reinstall the witness.
Steps
- Select .
- Select the checkbox next to the witness and select Modify.
- Modify the necessary fields and select Apply.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\