- Notes, cautions, and warnings
- Additional Resources
- Introduction
- Remote Systems
- Snapshots
- Protection Policies
- Replication
- Asynchronous replication
- Synchronous replication
- Pause a replication session
- Resume a replication session
- Failover
- Other considerations for replication
- Testing disaster recovery for NAS servers under replication
- Virtual volumes replication
- Metro Protection
- Pre-requisites and limitations
- Configure host connectivity
- Metro witness
- Configure a metro volume
- Configure a metro volume group
- Set the metro role
- Monitor metro resources
- Pause a metro resource
- Resume a metro resource
- Promote a metro resource
- Demote a metro resource
- End a metro resource
- Summary of allowed actions on a metro resource
- Using protection policies with metro
- Using QoS with metro
- Remote Backup
- NDMP Backup for NAS Servers
- Replication summary
- Use cases
Dell PowerStore Protecting Your Data
Other considerations for replication
During block replication, when the source system is paused for NDU and the destination system is up, the destination system status is changed to System_Paused. If the destination system is down during the source system NDU, when the destination system is up again, its status remains OK.
During file replication, when the source system is paused for NDU, the destination system remains in OK state regardless of its connectivity status.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\