- Notes, cautions, and warnings
- Getting started
- System concepts
- Storage environment
- Virtual storage
- Linear storage
- Disk groups
- RAID levels
- ADAPT
- Disk group utilities
- SSDs
- Spares
- Pools
- Changing pool settings
- Volumes and volume groups
- Volume cache options
- Overcommitting volumes
- About automated tiered storage
- Initiators, hosts, and host groups
- CHAP
- Host ports
- Attaching volumes to hosts
- Operating with a single controller
- Snapshots
- Copying volumes or snapshots
- Reconstruction
- Quick rebuild
- Updating firmware
- Managed logs
- LDAP
- DNS settings
- Peer connections
- Replication
- Full disk encryption
- Rescanning disks
- Clearing disk metadata
- Data protection during failover to a single controller
- SupportAssist
- About CloudIQ
- Event history
- Audit logs
- System metrics
- Dashboard
- Provisioning
- Working with volumes
- Volumes table
- Data protection table
- Creating volumes
- Modifying volumes
- Deleting volumes and snapshots
- Attaching volumes to hosts
- Detaching volumes from hosts
- Expanding volumes
- Rolling back virtual volumes
- Creating snapshots
- Resetting snapshots
- Copying volumes or snapshots
- Aborting a volume copy
- Add data protection
- Creating a replication set
- Modifying a replication set
- Deleting a replication set
- Initiating or scheduling a replication
- Suspending a replication
- Aborting a replication set
- Resuming a replication
- Managing replication schedules
- Working with hosts
- Working with volumes
- Settings
- Maintenance
- Other management interfaces
- Administering a log-collection system
- Settings changed by restoring defaults
- System configuration limits
- Best practices
- Glossary of terms
Dell PowerVault ME5 Series Administrator's Guide
Changing iSCSI configuration settings
The iSCSI configuration panel (Settings > iSCSI > Configuration) provides options for you to view the system's configuration, or to alter it if the network configuration was modified. Panel options include the ability to change the IP version and to enable/disable jumbo frames to allow for larger data transfers, CHAP, and iSNS. IPv4 uses 32-bit addresses. IPv6 uses 128-bit addresses
CAUTION Use extreme caution if making iSCSI configuration changes after onboarding. Modifications will disrupt connectivity to the host and disconnect the system from the network.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\