Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Precision 7560 Service Manual

PDF

Removing the inner frame

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the SD card.
  3. Remove the base cover.
  4. Remove the battery.
  5. Remove the WLAN card.
  6. Remove the WWAN card.
  7. Remove the primary M.2 SSD.

About this task

The figure indicates the location of the inner frame and provides a visual representation of the removal procedure.

Removing the inner frame

Steps

  1. For the computers shipped with WWAN card:
    1. Remove the (M2x3) screw that secures the Darwin bracket in place.
    2. Remove the Darwin bracket away from the computer.
    3. Disconnect the two Darwin antenna cables from the connector on the system board.
  2. Unroute the WLAN and WWAN antenna cables from the routing guide.
  3. Remove the eight (M2x5) and the nine (M2x2.5) screws that secure the inner frame to the computer chassis.
  4. Remove the inner frame from the computer.
    NOTE: If the thermal pad attached to the bottom side of the inner frame is detached, while removing the inner frame, adhere it back to its correct location.
    Inner frame thermal pads

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\