Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Precision 7560 Service Manual

PDF

Removing the display panel (non-touch)

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the SD card.
  3. Remove the secondary M.2 SSD.
  4. Remove the base cover.
  5. Remove the battery.
  6. Remove the SIM card.
  7. Remove the secondary memory.
  8. Remove the WLAN card.
  9. Remove the WWAN card.
  10. Remove the primary M.2 SSD.
  11. Remove the keyboard lattice.
  12. Remove the keyboard.
  13. Remove the SD card reader.
  14. Remove the GPU power cable.
  15. Remove the GPU card.
  16. Remove the primary memory.
  17. Remove the heat-sink assembly.
  18. Remove the inner frame.
  19. Remove the system board.
  20. Remove the speakers.
  21. Remove the middlecap.
  22. Remove the display assembly.
  23. Remove the display bezel.

About this task

The figure indicates the location of the display panel and provides a visual representation of the removal procedure.

Removing the display panel

Removing the display panel

Removing the display panel

Steps

  1. Remove the two (M2.5x2.5) screws and the two (M2x2.5) screws that secure the display panel to the display assembly.
  2. Lift the display panel and turn the display panel over to access the display cable.
  3. Peel the conductive tape covering the display cable.
  4. Peel the adhesive tapes that secure the display cable connector.
  5. Peel the adhesive rubber strip covering the display cable connector.
  6. Unlock the display cable connector and then disconnect the display cable from the back of the display panel.
  7. Remove the display panel form the display assembly.
  8. Remove the display panel.
    NOTE:The support brackets attached to the display panel are defined as a single service assembly part and cannot be further disassembled.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\