Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Precision 7560 Service Manual

PDF

Installing the display hinge (non-touch)

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the display hinge and provides a visual representation of the installation procedure.

Installing the display hinge

Steps

  1. Place the display hinge in its slot on the display assembly.
  2. Replace the eight (M2.5x2.5) screws to secure the display hinge to the display assembly.

Next steps

  1. Install the display panel.
  2. Install the display bezel.
  3. Install the display assembly.
  4. Install the middlecap.
  5. Install the speakers.
  6. Install the system board.
  7. Install the inner frame.
  8. Install the heat-sink assembly.
  9. Install the GPU card.
  10. Install the GPU power cable.
  11. Install the SD card reader.
  12. Install the keyboard.
  13. Install the keyboard lattice.
  14. Install the SIM card.
  15. Install the primary memory.
  16. Install the WWAN card.
  17. Install the WLAN card.
  18. Install the secondary memory.
  19. Install the primary M.2 SSD.
  20. Install the battery.
  21. Install the base cover.
  22. Install the secondary M.2 SSD.
  23. Install the SD card.
  24. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\