Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Precision 7560 Service Manual

PDF

Removing the display assembly

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the SD card.
  3. Remove the secondary M.2 SSD.
  4. Remove the base cover.
  5. Remove the battery.
  6. Remove the SIM card.
  7. Remove the secondary memory.
  8. Remove the WLAN card.
  9. Remove the WWAN card.
  10. Remove the primary M.2 SSD.
  11. Remove the keyboard lattice.
  12. Remove the keyboard.
  13. Remove the primary memory.
  14. Remove the heat-sink assembly.
  15. Remove the system board.
  16. Remove the power-adapter port.

About this task

The figure indicates the location of the display assembly and provides a visual representation of the removal procedure.

Removing the display assembly

Removing the display assemblyRemoving the display assembly

Removing the display assembly

Steps

  1. Open the display assembly to a 45-degree angle and place the computer at the edge of a flat table so that the display assembly can extend below the table.
    NOTE:For computers shipped with IR camera configuration, disconnect the display cable and IR camera cable.
  2. Peel the adhesive tapes and flip the power button board FFC to access the WWAN cables and the Darwin cables.
  3. Peel and remove the WWAN cables and the Darwin cables from the palmrest.
  4. Remove the eight (M2.5x2.5) screws that secure the hinges to the palmrest.
  5. Remove the display assembly from the palmrest.
    NOTE:The touch display assembly for Precision 7560 is a Hinge-Up Design (HUD) assembly and cannot be further disassembled once it is removed from the bottom chassis. If any components in the touch display assembly are malfunctioning and need to be replaced, replace the entire touch display assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\