Activating the copy session starts the copy from the source device to the target device, and places the target device in the Read/Write state. The target host can access the cloned data and has access to data on the source host until the copy session is terminated.
NOTE Cloned data is made available as a point-in-time copy at the time of activation and not at the time that the session was created.
To activate the clone copy session between target device and source device, enter:
symclone -g ProdDB activate
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\