Concurrent TimeFinder/Clone
The following image shows the relationship between devices for a TimeFinder/Clone pairing of a source device with two targets.
NOTEThe positions of Target 1 and Target 2 are interchangeable in the illustration above.
In the following table:
- Pair state refers to the current state of the Source-Target 1 pair.
- Operation refers to the intended control operation on the Source-Target 2 pair.
- Y indicates that the operation is allowable for that state.
2 This state is not available on
PowerMaxOS 10 (6079) and higher.
3 Requires -concurrent flag only for dgleg operations.
4 Session must be differential.
5 All Clone sessions on
PowerMaxOS 10 (6079) and higher are differential.
6 If not already set to this mode.
7 Cannot be differential.
8 Requires -symmforce (not recommended).
9 Target data will be incomplete.
10 Source data will be incomplete.