Dell Solutions Enabler 10.0.0 TimeFinder/Clone CLI User Guide

Description

Terminating a copy session deletes the pairing information in the array and removes any hold on the target device. Terminating a session while the device pairs are in the CopyInProg state causes the session to end. If the application has not finished accessing all of the data, the target copy is not a full copy.

The symclone terminate command is allowed for all clone pair states.

Examples

To terminate the copy session for device pair, enter:

symclone -g ProdDB terminate

If the state is CopyInProg, then apply the -symforce option to terminate the session. This leaves the target copy as an incomplete copy.

If the -not_ready option is applied to the copy session, Solutions Enabler leaves the target devices in their prior Ready or NotReady state at the completion of the terminate operation. If the -not_ready option is not applied to the copy session, Solutions Enabler leaves the target devices in the Ready state at the completion of the terminate, regardless of their state prior to the terminate operation.