- Notes, cautions, and warnings
- Preface
- Introduction to TimeFinder/Clone
- TimeFinder/Clone operations on SGs
- TimeFinder/Clone operations on DGs, and CGs
- TimeFinder/Clone overview
- Create TimeFinder clone copy session
- Activate a TimeFinder clone copy session
- Recreate TimeFinder clone copy device
- Restore data from target device
- Split a clone device pair
- Terminate TimeFinder clone copy session
- Query TimeFinder clone copy session pairs
- Verify TimeFinder clone copy session pair states
- TimeFinder cascaded clone copy session
- Creating multiple clone copies from a standard device
- Using composite groups to manage clone pairs across arrays
- Command options with device files
- TimeFinder State Rules Reference
- SRDF State Rules Reference
Dell Solutions Enabler 10.0.0 TimeFinder/Clone CLI User Guide
Recreate TimeFinder clone copy session using the establish command
Description
Use the symclone establish command, to recreate and then immediately activate a copy session with a single command.
Options
- -concurrent
- Activates an existing clone session for an additional clone pair in a group.
Examples
To recreate and then activate a previous copy session, enter:
symclone -g ProdDB establish
NOTE The
symclone establish command sets the target device to
Not Ready for a short period time. If using a filesystem, unmount the target host before performing the
establish command.
To recreate and then activate a copy session for an additional clone pair in group ProdDB, enter:
symclone -g ProdDB establish -concurrent
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\