Use the
symclone recreate command to incrementally copy all subsequent changes made to the source device (made after the point-in-time copy was activated) to the target device.
Example
To recreate the copy session between target device and source device in group
ProdDB, enter:
symclone -g ProdDB recreate
Restrictions
The following restrictions apply for the
symclone recreate operation:
The session must have been activated to establish the new point-in-time copy.
While in the
Recreated state, the target device remains
Not Ready to the host.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\