- Notes, cautions, and warnings
- Views of Vostro 15 3530
- Set up your Vostro 15 3530
- Specifications of Vostro 15 3530
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Ethernet
- Wireless module
- Audio
- Storage
- Media-card reader
- Keyboard
- Keyboard shortcuts of Vostro 15 3530
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- Sensor
- GPU—Integrated
- GPU—Discrete
- Hardware security
- Operating and storage environment
- Dell support policy
- ComfortView
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Battery
- Heat sink
- Touchpad
- I/O daughter-board cable
- I/O daughter-board
- Power button
- Power button with optional fingerprint reader
- Power-adapter port
- Display assembly
- Display hinge caps
- Display bezel
- Display hinges
- Display panel
- Camera
- Display cable
- Display back-cover and antenna assembly
- System board
- Palm-rest and keyboard assembly
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Vostro 15 3530 Owner's Manual
Installing the power button with optional fingerprint reader
CAUTION:The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:This procedure applies only to computers shipped with a power button with optional fingerprint reader installed.
The following image indicates the location of the power button with optional fingerprint reader and provides a visual representation of the installation procedure.
Steps
- Place the power button with optional fingerprint reader in the slot on the palm-rest and keyboard assembly.
- Align the screw hole on the power button with optional fingerprint reader to the screw hole on the palm-rest and keyboard assembly.
- Replace the screw (M2x2) to secure the power button with optional fingerprint reader to the palm-rest and keyboard assembly.
- Adhere the tape to secure the optional fingerprint-reader flexible printed circuit to the palm-rest and keyboard assembly.
Next steps
- Install the I/O daughter-board.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\