Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Vostro 15 3530 Owner's Manual

PDF

Removing the palm-rest and keyboard assembly

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the memory module.
  4. Remove the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever applicable.
  5. Remove the wireless card.
  6. Remove the speakers.
  7. Remove the fan.
  8. Remove the heat sink - integrated or the heat sink - discrete, whichever applicable.
  9. Remove the 3-cell battery or the 4-cell battery, whichever applicable.
  10. Remove the touchpad.
  11. Remove the I/O daughter-board cable.
  12. Remove the I/O daughter-board.
  13. Remove the power button or the power button with optional fingerprint reader, whichever applicable.
  14. Remove the power-adapter port.
  15. Remove the display assembly.
  16. Remove the system board.
    NOTE:When removing the system board to replace/access other parts, the system board can be removed with the heat sink attached to it in order to simplify the procedure and preserve the thermal bond between the system board and heat sink.

About this task

NOTE:The palm-rest and keyboard assembly cannot be further disassembled once all the pre-removal parts procedures are completed. If the keyboard is malfunctioning and is required to be replaced, replace the entire palm-rest and keyboard assembly.

The image below shows the palm-rest and keyboard assembly after the pre-removal parts procedures have been performed for any palm-rest and keyboard assembly replacement.

Image of palm-rest and keyboard assembly

Steps

  1. For computers shipped with an aluminum chassis and a 4-cell battery installed, remove the two screws (M2x2) that secure the left RF metal wall bracket to the palm-rest and keyboard assembly.
    Image of removing the screws on the RF metal bracket
  2. For computers shipped with an aluminum chassis, remove the right and left RF metal wall bracket from the palm-rest and keyboard assembly.
    NOTE:The left and right RF metal wall brackets MUST be transferred to the replacement palm-rest and keyboard assembly.
    Image of transferring the RF metal brackets to the replacement palm-rest and keyboard assembly
  3. After performing the pre-requisites, you are left with the palm-rest and keyboard assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\