Vostro 15 3530 Owner's Manual

Installing the power-adapter port

CAUTION:The information in this section is intended for authorized service technicians only.

If you are replacing a component, remove the existing component before performing the installation procedure.

The following images indicate the location of the power-adapter port and provide a visual representation of the installation procedure.

Image of installing the power adapter port

Align and place the power-adapter port in the slot on the palm-rest and keyboard assembly.
NOTE:The power-adapter port is secured in place by the right display hinge. There is no screw, tape, or adhesives securing the power-adapter port to the palm rest. As a result, technicians should take note of whether the power-adapter port has fallen out of the computer during subsequent removal procedures.
Connect the power-adapter port cable to the connector on the system board.
Close the right display hinge downwards to align the screw holes on the right display hinge to the screw holes on the system board and the palm-rest and keyboard assembly.
Replace the two screws (M2.5x5) to secure the right display hinge to the system board and the palm-rest and keyboard assembly.