Vostro 15 3530 Owner's Manual

Installing the speakers

If you are replacing a component, remove the existing component before performing the installation procedure.

NOTE:If the rubber grommets are pushed out when removing the speakers, push them back in before replacing the speakers.

The following image indicates the location of the speakers and provides a visual representation of the installation procedure.

Image of installing the speakers

Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest and keyboard assembly.
NOTE:Ensure that the alignment posts are threaded through the rubber grommets on the speakers.
Route the speaker cable along the bottom side of the palm-rest and keyboard assembly, over the wireless-antenna cables. Then secure the speaker cable into the routing guides on the palm-rest and keyboard assembly.
NOTE:The speaker cable must be routed through the routing guides to avoid damaging the speaker cable when installing the base cover.
Connect the speaker cable to the connector on the system board.