- Notes, cautions, and warnings
- Safety instructions
- Removing and installing components
- Device drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Alienware m15 R2 Service Manual
Installing the fan and heat-sink assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
CAUTION: If either the processor or the heat sink is replaced, use the thermal
grease provided in the kit to ensure that thermal conductivity is
achieved.
About this task
The following image indicates the location of the fan and heat-sink assembly and provides a visual representation of the installation procedure.
Steps
- Place the fan and heat-sink assembly on the system board.
- In sequential order (1>2>3>4>5>6) replace the six screws (M2x3) that secure the fan and heat-sink assembly to the system board.
- Connect the left and right fan cables to the system board.
Next steps
- Install the system board.
- Install the right I/O-board.
- Install the battery.
- Install the rear I/O-cover.
- Install the 2230 solid-state drive. (if applicable)
- Install the 2280 solid-state drive. (if applicable)
- Install the base cover.
- Follow the procedure in After working inside your computer.
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
この記事は役に立ちましたか?
コメントでは、以下の特殊文字は利用できません: <>()\