- Notes, cautions, and warnings
- Safety instructions
- Removing and installing components
- Device drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Alienware m15 R2 Service Manual
Removing the fan and heat-sink assembly
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
- Remove the 2230 solid-state drive. (if applicable)
- Remove the 2280 solid-state drive. (if applicable)
- Remove the rear I/O-cover.
- Remove the battery.
- Remove the right I/O-board.
- Remove the system board.
About this task
NOTE: The heat
sink may become hot during normal operation. Allow sufficient time
for the heat sink to cool before you touch it.
CAUTION: For
maximum cooling of the processor, do not touch the heat transfer areas
on the heat sink. The oils in your skin can reduce the heat transfer
capability of the thermal grease.
The following image indicates the location of the fan and heat-sink assembly and provides a visual representation of the removal procedure.
Steps
- Disconnect the left and right fan cables from the system board.
- In the reverse sequential order (6>5>4>3>2>1) remove the six screws (M2x3) that secure the fan and heat-sink assembly to the system board.
- Lift the fan and heat-sink assembly from the system board.
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
この記事は役に立ちましたか?
コメントでは、以下の特殊文字は利用できません: <>()\