- Notes, cautions, and warnings
- Safety instructions
- Removing and installing components
- Device drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Alienware m15 R2 Service Manual
Removing the rear I/O-cover
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
About this task
The following image indicates the location of the rear I/O-cover and provides a visual representation of the removal procedure.
Steps
- Peel and lift the Mylar covering the system board.
- Disconnect and peel the Tron light cable from the system board and route the cable through the slot on the Mylar.NOTE: To prevent damaging your computer ensure the Tron light cable has been disconnected from the system board before removing the rear I/O-cover.
- Remove the two screws (M2.5x5) that secure the rear I/O-cover to the palm-rest assembly.
- Firmly grasp the sides of your computer with both hands and push the rubber feet on the rear I/O-cover outwards with your thumbs to release the rear I/O-cover from the palm-rest assembly.
- Lift the rear I/O-cover from the palm-rest assembly.
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
この記事は役に立ちましたか?
コメントでは、以下の特殊文字は利用できません: <>()\