- Notes, cautions, and warnings
- Safety instructions
- Removing and installing components
- Device drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Alienware m15 R2 Service Manual
Removing the M.2 2230 solid-state drive
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
About this task
NOTE: This procedure applies only to computers shipped with a M.2 2230 solid-state drive installed.
NOTE: Depending on the configuration ordered your computer may have up to two M.2 cards installed. Supported card configurations per M.2 card slot:
- M.2 2230 solid-state drive + 2230 mounting bracket
- M.2 2280 solid-state drive
The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the removal procedure.
Steps
- Remove the screw (M2x3) that secures the M.2 thermal shield to the mounting bracket.
- Remove the M.2 2230 thermal shield from the M.2 2230 solid-state drive.
- Lift and remove the M.2 2230 solid-state drive from the M.2 card slot on the system board.
- Remove the screw (M2x3) that secures the M.2 2230 mounting bracket to the palm-rest assembly.
- Remove the M.2 2230 mounting bracket from the palm-rest assembly.
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
この記事は役に立ちましたか?
コメントでは、以下の特殊文字は利用できません: <>()\