- Notes, cautions, and warnings
- Safety instructions
- Removing and installing components
- Device drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Alienware m15 R2 Service Manual
Removing the keyboard-controller board
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
- Remove the 2230 solid-state drive. (If applicable)
- Remove the 2280 solid-state drive. (If applicable)
- Remove the battery.
About this task
The following image indicates the location of the keyboard-controller board and provides a visual representation of the removal procedure.
Steps
- Remove the two screws (M2x1.9) that secure the keyboard-backlight cable to the keyboard-controller board.
- Disconnect the keyboard-backlight cable from the keyboard-controller board.
- Open the latch and disconnect the keyboard-controller board cable from the keyboard-controller board.
- Open the latch and disconnect the keyboard cable from the keyboard-controller board.
- Pull on the securing tab to release the keyboard-controls board from the palm-rest assembly.
- Using the plastic tab, pry and remove the keyboard-controller board from the palm-rest assembly.
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
この記事は役に立ちましたか?
コメントでは、以下の特殊文字は利用できません: <>()\