- Notes, cautions, and warnings
- Safety instructions
- Removing and installing components
- Device drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Alienware m15 R2 Service Manual
Installing the rear I/O-cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the rear I/O-cover and provides a visual representation of the installation procedure.
Steps
- Push the rear I/O-cover into the palm-rest assembly snapping it into place.NOTE: To avoiding damaging your computer, ensure the Tron light cable is not pinched and that the Mylar is pasted on the system board before snapping the rear I/O-cover into place.
- Replace the two screws (M2.5x5) that secure the rear I/O-cover to the palm-rest assembly.
- Peel and lift the Mylar from the system board.
- Route the Tron light cable through the slot on the Mylar.
- Connect the Tron light cable to the system board.
- Route and adhere the Tron light cable into place on the system board.
- Adhere the Mylar into place onto the system board.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
この記事は役に立ちましたか?
コメントでは、以下の特殊文字は利用できません: <>()\