CMC モジュール内の SD カードが別のサービスタグにバインドされている。 |
$racadm featurecard -s
|
The feature card inserted is valid and contains the following feature(s)
FlexAddress: bound to another chassis, svctag = <Service tag Number> SD card SN = <Valid flex address serial number>
|
同じサービスタグにバインドされている CMC モジュール内の SD カード。 |
$racadm featurecard -s
|
The feature card inserted is valid and contains the following feature(s)
FlexAddress: bound
|
どのサービスタグにもバインドされていない CMC モジュール内の SD カード。 |
$racadm featurecard -s
|
The feature card inserted is valid and contains the following feature(s)
FlexAddress:not bound
|
何らかの理由でシャーシに FlexAddress 機能がない(シャーシ上SD カードが挿入されていない / SD カードが破損している / 機能の非アクティブ化後 / SD カードが異なるシャーシにバインドされている)。 |
$racadm setflexaddr [-f
<fabricName> <slotState>]
$racadm setflexaddr [-i
<slot#> <slotstate>]
|
ERROR: Flexaddress feature is not active on the chassis
|
ゲストユーザーによるスロット / ファブリックへの FlexAddress の設定試行。 |
$racadm setflexaddr [-f
<fabricName> <slotState>]
$racadm setflexaddr [-i
<slot#> <slotstate>]
|
ERROR: Insufficient user privileges to perform operation
|
シャーシの電源がオンの状態での FlexAddress 機能の無効化。 |
racadm feature -d -c flexaddress
|
ERROR: Unable to deactivate the feature because the chassis is powered ON
|
ゲストユーザーがシャーシ上の機能の無効化を試みる。 |
racadm feature -d -c flexaddress
|
ERROR: Insufficient user privileges to perform operation
|
サーバーモジュールの電源がオンの状態で、スロット / ファブリックの FlexAddress 設定を変更する。 |
$racadm setflexaddr -i 1 1
|
ERROR: Unable to perform the set operation because it affects a powered ON server
|
CMC Enterprise ライセンスがインストールされていないときの、スロットまたはファブリックの Flexaddress 設定変更。 |
$racadm setflexaddr -i<スロット番号> <状況>
$racadm setflexaddr -f<ファブリック名> <状況>
|
ERROR: SWC0242 : A required license is missing or expired. Obtain an appropriate license and try again, or contact your service
provider for additional details.
-
注: この問題を解決するには、
FlexAddress の有効化 ライセンスが必要です。
|