- Notes, cautions, and warnings
- About this document
- Dell EMC PowerEdge C4140 system overview
- Initial system setup and configuration
- PowerEdge C4140 installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Air shroud
- Cooling fans
- Hard drives
- Intrusion switch
- System memory
- Expansion cards and expansion card risers
- Processor and heat sink
- Network daughter card
- System battery
- Optional internal USB memory key
- Graphics processing unit
- PCIe Graphics processing unit
- GPU installation guidelines
- Removing a GPU riser cable from the GPU switch board
- Removing a GPU
- Removing a GPU riser cable board
- Removing the GPU brackets from the GPUs removed from your system
- Removing the GPU brackets from the replacement GPUs
- Removing the GPU switch board
- Installing the optional GPU switch board
- Installing the custom GPU brackets on the replacement GPUs
- Installing the GPU brackets on the GPUs removed from your system
- Installing a GPU riser cable board
- Installing a GPU
- Installing a GPU riser cable on the GPU switch board
- GPU cabling diagrams
- SXM2 Graphics processing unit
- Power supply units
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics
- Getting help
- Documentation resources
Dell EMC PowerEdge C4140 Installation and Service Manual
Installing a 2.5-inch cabled drive into the drive cage
Prerequisites
NOTE To identify the drive, see the label on the drive cable. For more information, see Drive Specifications in the PowerEdge
C4140 Technical Specs at
.www.dell.com/poweredgemanuals.
- Follow the safety guidelines listed in the Safety instructions section.
- Keep the Phillips #2 screwdriver ready.
- Remove the 2.5-inch drive cage.
- Remove the 2.5-inch drive cage cover.
Steps
To install drive 0 and drive 1, perform the following steps:
Figure 1. Installing a 2.5-inch cabled drive in the drive cage 
- Slide drive 1 into the drive cage.
- Lower drive 0 into the drive cage.
- Secure the drives to the drive cage by using the screws.
- NOTE If the 2.5-inch drive has Torx screw, use Torx 6 screwdriver to secure the drives to the drive cage.Connect the power and signal cable to the drives.
NOTE Ensure that the connector labeled HDD0 is plugged into upper drive before reinstalling bay.
Next steps
- Install the 2.5-inch drive cage cover.
- Install the drive cage into the drive cage slot.
- Connect the power and signal cables to the system board.
- Follow the procedure listed in After working inside your system.
- Enter System Setup and ensure that the drive's controller is enabled.
- Exit the System Setup program and reboot the system.
- Install any software required for the drive operation as described in the documentation for the drive.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\