Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

neighbor

Define a neighbor router with which to exchange RIP information.

Syntax

neighbor ip-address

To delete a neighbor setting, use the no neighbor ip-address command.

Parameters

ip-address

Enter the IP address, in dotted decimal format, of a router with which to exchange information.

Defaults

Not configured.

Command Modes

ROUTER RIP

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

When a neighbor router is identified, unicast data exchanges occur. Multiple neighbor routers are possible.

To ensure that only specific interfaces are receiving and sending data, use the passive-interface command with the neighbor command.

Related Commands

passive-interface — sets the interface to only listen to RIP broadcasts.