Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show configuration lock

Display the configuration lock status.

Syntax

show configuration lock

Defaults

None

Command Modes

EXEC Privilege

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
8.3.17.0	Supported on the M I/O Aggregator.

Usage Information

The type may be auto, manual, or rollback. When set to auto, Dell Networking OS automatically denies access to CONFIGURATION mode to all other users every time the user on the listed VTY line enters CONFIGURATION mode. When set to manual, the user on the listed VTY line must explicitly set the lock each time before entering CONFIGURATION mode. Rollback indicates that Dell Networking OS is in a rollback process. The line number shown in the output can be used to send the messages to that session or release a lock on a VTY line.

Example

Dell#show configuration lock
                                             Configure exclusively locked by the following line:
                                             Line              : vty 0
                                             Line number       : 2
                                             User             : admin
                                             Type             : AUTO
                                             State            : LOCKED
                                             Ip address        : 10.11.9.97
                                             Dell#